220V 30W Power Led Board Module IP65 6000-6500K White

This high-efficiency COB LED board module mounts the light engine on an aluminum PCB (MCPCB) with an integrated Smart-IC driver, allowing it to run directly from AC220–240V mains without an external LED driver. Designed for robust performance and easy retrofits, it’s ideal for hobby lighting projects, fixture repairs, and custom luminaires where a compact, mains-powered light source is required.

With its IP65 rating, cool white 6000–6500K output, and Ra80 CRI, this module delivers bright, neutral illumination suitable for workshops, garages, and task lighting. Ensure proper thermal management with a suitable heatsink for long service life.

✨ Key Features

• Direct 220–240V AC input — no external LED driver required 🔌
• 30W power class for bright, uniform output
• 6000–6500K cool white CCT for crisp visibility
• Ra80 CRI for reliable color rendering
• IP65 dust- and water-resistant construction 🌧️
• Aluminum MCPCB for efficient heat dissipation
• Integrated Smart-IC control for simplified wiring
• Wide 270° beam angle for broad area coverage
• Rated 30,000 hours lifespan with a proper heatsink

📐 Technical Specifications

• Power: 30W
• Input Voltage: AC220–240V (supports 220V / 230V / 240V)
• LED Chip Model: SMD Smart-IC, COB
• Color Rendering Index (CRI): Ra80
• Correlated Color Temperature (CCT): White 6000–6500K
• Beam Angle: 270°
• Lifespan: 30,000 hours (with good heatsink)
• Ingress Protection: IP65
• Housing / PCB Material: Aluminum

🚀 Applications & Use Cases

• DIY and hobby lighting projects
• Repairing or upgrading faulty luminaires and floodlights
• Workshop, garage, task, and utility lighting
• Prototyping with electronics components and modules (mains-side lighting)
• Integration into systems switched by Arduino or Raspberry Pi via a properly rated relay/SSR (indirect control — not low-voltage)

🛠️ Thermal & Installation Notes

• Mount the module to a suitably sized heatsink using thermal paste or pads to maintain the specified lifespan.
• Ensure secure mechanical mounting and strain relief for mains wiring.
• Maintain proper electrical insulation and clearances around live parts.
• IP65 performance depends on installation quality; use appropriate gaskets, enclosures, and sealed connectors where required.

⚠️ Safety Information — High Voltage

• Danger: Mains voltage (AC220–240V). Only qualified users should install and service this product.
• Always disconnect power before handling. Do not touch when energized.
• Prevent short circuits and ensure adequate insulation of all connections.
• Avoid contact with liquids; moisture ingress can cause electric shock or failure.
• This module is not intended for direct microcontroller drive or low-voltage PWM. Use isolation (e.g., relay/SSR rated for mains) if control is needed.
• Use appropriate fusing and observe local electrical codes.

Engineers and makers will appreciate the simplicity of a mains-ready COB LED module for rapid lighting builds, while hobbyists benefit from easy integration into Arduino or Raspberry Pi-based projects through safe, isolated switching. This component streamlines lighting design where voltage conversion and external drivers are undesirable.