220V 20W Power Led Board Module IP65 2800-3200K Warm White

This high-efficiency LED module integrates a COB LED onto an aluminum PCB with an on-board Smart IC driver, enabling direct connection to AC 220–240V household mains. No external LED driver is required, making it ideal for both DIY lighting and fixture repair projects.
Designed for electronics engineers and hobbyists, this module can be switched via relay/SSR in microcontroller-based systems (e.g., Arduino, Raspberry Pi) while maintaining proper mains isolation.

Key Features ⚙️

• Direct AC input: 220–240V operation – no separate driver needed.
• 20W output with warm white color temperature (2800–3200K) for cozy, ambient lighting.
• COB LED with integrated SMD Smart IC for stable current regulation.
• CRI ≥ Ra80 for accurate, natural color reproduction.
• Wide 270° beam angle for uniform illumination.
• Aluminum substrate for efficient heat dissipation; supports long life with proper heatsinking.
• IP65 rating for dust-tight and water-jet resistance (ensure sealed installation to maintain rating).

Technical Specifications 📐

• Power: 20W
• Input Voltage: AC 220–240V (supports 220V / 230V / 240V)
• LED Chip Model: SMD Smart IC + COB
• Color Rendering Index (CRI): Ra80
• Correlated Color Temperature (CCT): Warm White 2800–3200K
• Beam Angle: 270°
• Lifespan: Up to 30,000 hours (with a suitable heatsink)
• Housing/PCB Material: Aluminum
• Ingress Protection: IP65

Applications 🛠️

• Repair or retrofit of household and industrial lighting fixtures.
• Custom luminaires, task lighting, accent lighting, and DIY projects.
• Microcontroller-based automation (Arduino, Raspberry Pi) via isolated relay or solid-state relay (SSR) for safe on/off control of mains voltage.

Installation & Thermal Management 🧊

• Mount the module on an appropriately sized heatsink using thermal paste or a thermal pad to achieve the stated lifespan.
• Ensure adequate ventilation and avoid enclosed spaces without thermal management.
• Use insulated standoffs and observe creepage/clearance around mains-connected pads.
• To maintain the IP65 rating, install in a suitably sealed enclosure and protect all wiring/connection points.

Safety Notice ⚠️

• This product operates from AC 220–240V mains. Improper handling can cause electric shock, fire, or injury.
• Ensure electrical insulation on all connections and avoid exposure to liquids or condensation.
• Verify there are no short circuits before powering.
• Disconnect power before installation or servicing. Installation should be performed by qualified personnel familiar with mains voltage and safety standards.

Compatibility Notes 🔌

• Not for direct connection to low-voltage microcontrollers (Arduino, Raspberry Pi). Use an appropriately rated, isolated relay/SSR to switch mains power.
• Use only within the specified voltage range (AC 220–240V).

Optimize your lighting projects with a robust, driverless LED module that integrates seamlessly into electronics builds and repairs, while following proper mains safety and thermal practices.