LilyPad LED Module – Red 🔴

Bring your wearable builds and e-textiles to life with the Red LilyPad LED Module. Purpose‑built for wearable electronics and fabric-based projects, this ultra‑light, low‑profile module stitches or solders seamlessly into garments, accessories, and interactive textiles—perfect for Arduino, Raspberry Pi, and other microcontroller platforms.

Key Features ✨

• Bright red illumination for clear, attention‑grabbing indicators and accents.
• Sewable pads (+/–) designed for conductive thread or standard wire soldering.
• Integrated current‑limiting resistor for safe, direct drive from typical MCU I/O pins.
• PWM dimmable for fades, blinks, and custom effects via your microcontroller.
• Polarity markings ensure easy, error‑free installation.
• Ultra‑thin, lightweight PCB optimized for fabrics and wearability.
• Compatible with LilyPad ecosystem modules, sensors, and microcontrollers.

Technical Details ⚙️

• Color: Red LED
• Interface: Two sewable pads (marked + and –)
• Drive: On/off or PWM control from a microcontroller GPIO
• Power: Low‑power operation; suitable for battery‑powered wearables
• Typical use voltage: Compatible with 3.3 V and 5 V controller ecosystems (observe your MCU’s current limits)

Applications 💡

• Wearable electronics, e‑textiles, and smart garments
• Costumes, cosplay, and illuminated accessories
• Interactive art, exhibits, and prototypes
• STEM education kits and DIY electronics projects

Compatibility & Control 🔗

Works seamlessly with LilyPad microcontrollers and is easy to integrate with popular platforms like Arduino, ESP32/ESP8266, micro:bit, and Raspberry Pi. Drive directly from a digital pin (thanks to the on‑board resistor) or use PWM for brightness control. On Raspberry Pi (3.3 V GPIO), keep total current within safe limits; for multiple LEDs or higher brightness, use a transistor or MOSFET driver.

Quick Start 🧵

• Connect the + pad to your microcontroller’s digital/PWM pin or VCC.
• Connect the – pad to GND.
• Set the pin HIGH/LOW for on/off control, or use PWM for dimming.
• Prototype on a bench, then sew into fabric using conductive thread.

Why Choose This Module ✅

Engineered with durable materials and a minimal footprint, the LilyPad LED Module – Red offers dependable, long‑term performance in textiles. Its ease of integration, on‑board resistor, and compatibility with common electronics components and modules make it a go‑to choice for both engineers and hobbyists.