220V 5W Power Led Board Modul IP65 Y27 2800-3200K Warm White

This compact COB LED board module integrates a Smart IC driver on an aluminum PCB, enabling direct connection to AC 220–240 V mains without an external LED driver. Delivering 5 W of warm white (2800–3200K) light with a wide 270° beam angle, it is ideal for lighting repairs, DIY fixtures, and electronics projects where a slim, efficient light source is required. Rated IP65, it’s suitable for protected outdoor or damp environments when properly installed.

✨ Key Features

• Driverless 220V operation ⚡ — built-in Smart IC; no external LED driver required
• 5W warm white output — pleasant 2800–3200K for ambient lighting
• Wide 270° beam angle — excellent area illumination
• Aluminum PCB 🧊 — efficient heat spreading; supports long life with adequate heatsinking
• Ra ≥ 80 CRI — natural color rendering for general lighting
• IP65 🛡️ — dust-tight and water-jet resistant when correctly sealed in your assembly
• Long service life — up to 30,000 hours with proper thermal management

🧰 Applications

• Repair of faulty lamps and luminaires
• Custom fixtures and hobby lighting projects
• Prototyping with electronics components and lighting modules
• Microcontroller-based control (on/off) via relays or SSRs with Arduino or Raspberry Pi (mains isolation required)

📐 Technical Specifications

• Power: 5 W
• Input Voltage: AC 220–240 V (supports 220 V / 230 V / 240 V)
• LED Chip Type: SMD Smart IC + COB
• Color Rendering Index (CRI): Ra ≥ 80
• Correlated Color Temperature (CCT): Warm White 2800–3200 K
• Beam Angle: 270°
• Lifespan: up to 30,000 hrs (with good heatsink)
• Housing / Board Material: Aluminum
• Ingress Protection: IP65
• Model / Series: Y27

🧯 Safety & Handling (Read Before Use)

WARNING: This module is powered directly from mains voltage (AC 220–240 V). Treat all connections and exposed pads as live during operation.

• Electrical insulation: Ensure proper isolation, strain relief, and creepage/clearance when wiring.
• No liquids: Prevent contact with moisture. Maintain IP65 only when correctly sealed in an appropriate enclosure or luminaire.
• Short-circuit avoidance: Verify wiring and mounting to avoid shorts.
• Service by qualified persons: Disconnect power before installation or handling.

🌡️ Thermal Management

Mount the module to a suitable heatsink or thermally conductive surface using thermal compound or pads. Adequate cooling is essential to achieve the specified 30,000-hour lifespan and to maintain light quality.

🔗 Integration Tips for Arduino / Raspberry Pi

• Control on/off switching using a properly rated relay or solid-state relay (SSR) module with mains isolation.
• Do not directly interface the LED board to a microcontroller’s GPIO.
• Dimming is not guaranteed; use only if the driver specifically supports it (not specified here).

Whether you are an electronics engineer designing fixtures or a hobbyist building a custom lamp, this COB LED module offers a reliable, space-efficient solution for 220V lighting projects.